KIDES DUO KPL., profile, REF. 18032ANODA
SUITABLE FOR OUTDOOR USE
LINE OF LIGHT
AESTHETIC WALL LIGHTING FIXTURE
KIDES DUO KPL. extrusion is used for the construction of rain and snow fall resistant wall lighting fixtures. The extrusions are adapted to light down and up. It is also possible to cover the light sources of the extrusion, which gives the lighting fixture a smooth and aesthetic appearance. Used for this purpose is an additional extrusion – ATRA panel.
KIDES DUO KPL. END CAPS FOR OUTDOOR APPLICATIONS SOON AVAILABLE!
Fixtures made of KIDES DUO KPL. series extrusions are made for indoor and outdoor applications. They are resistant to rain and snow, but are not IP68 rated (they cannot be immersed in water). They should be mounted in accordance with the guidelines contained in the manual. When used outdoors, use only KIDES DUO series end caps. When used indoors, the above-mentioned caps can be used, or simplified caps from KIDESIN DUO. series for indoor applications.
KIDES DUO extrusion has two LED compartments, which enables it to direct light up and down. Optionally, an ATRA extrusion can be applied to cover the whole KIDES DUO KPL. lighting fixture. The light sources are then invisible, and only offer aesthetic illumination. The external plane of the ATRA extrusion can be finished in the same way as the surface on which a ready fixture is mounted. Due to this, aluminum is invisible, and left is only light distributed across the surface.
KIDES DUO KPL. is made of TEKIDES DUO mounting extrusion and OKIDES DUO extrusion. Additionally, an upper compartment can come with a special extrusion called DES INSERT for LEDs which protects them against water. There is also a dedicated KIDES cover for the upper compartment. As regards the lower compartment, 22 series covers are applied. There is space for power supplies provided inside the extrusion. Following the mounting of TEKIDES DUO extrusion on the surface and after power supply cable has been installed, click-mount OKIDES DUO extrusion. If ATRA extrusion is used, it should be suitably milled and installed before the end caps are applied. Mounting details are inlcuded in the manual.